4.3 Initial Test and Configuration

1. Upon connection to the PC, the charge LED should light-up yellow (charging) or green (charged). The operating LED should blink once per second.

 

2. Go into Start\All Programs\Noise_Sentry_RT_WiFi_Manager and run Noise_Sentry_RTW_Manager.exe. The front-panel described in Figure 2 appears, and the application tries to connect to the instrument. If it fails to find the instrument it indicates No Device Found. If this is the case see section Troubleshooting

3. Otherwise the application switches-on the Noise-Sentry-RT-Wireless Network and starts communicating with it.

4. If the Time and Date in the upper right corner of the application window are not properly adjusted the application asks if you want the instrument time to be synchronized to the PC time. Only say YES if the PC time is correct.

5. In addition, the application detects if the time zone of the instrument is different from the time zone of the PC. If it is, the application asks to set the instrument to the same time zone as the PC.

 

Note: If (in rare cases) the instrument is not intended to be used in the same time zone as that of the PC, we suggest to temporarily change the PC’s time zone to the time zone where the instrument will be recording, let the application set the instrument to the PC’s time zone, and change the PC’s time zone back after that initial setting. Afterwards if/whenever the application asks to change the instrument time zone back to the PC’s time zone, simply choose to cancel the adjus™ent.

 

6. In the front-panel of the application you should see the acoustic signal display in real-time.